Doepfer

A-190-8 MIDI/USB-to-Clock/Start/Stop

Termékkód: A-190-8
Mennyiségi egység: db

    49.900 Ft 49.900 Ft 49900.0 HUF

    49.900 Ft

    Ez a kombináció nem létezik.

    Kosárba Gyorsvásárlás

    USB/Midi-to-Sync Interface



    Alap jótállási idő: 1 év

     

    Module A-190-8 is a Midi/USB to Sync interface. The main application of the module is the control of clocked A-100 modules like sequencers (A-155),  sequencer controllers (A-154), trigger divider (A-160 or A-163), trigger sequencer (A-161) and similar units. It may be used also to reset or sync LFOs (e.g. A-145, A-147, A-143-4) or to trigger envelope generators (A-140, A-141-2, A-143-1, A-143-2) with a fixed clock rate.

    These are the most important features of this version of the module:

    • Midi input (recognizes only Midi realtime messages clock, start, stop and continue)
    • USB input for Midi via USB
    • Clock outputs:
      • 96: outputs the Midi clock 1:1 (96 pulses per measure/ppm or 24 pulses per quarter note/ppq)
      • 32: outputs the Midi clock divided by 3 (32 pulses per measure/ppm or 8 pulses per quarter note/ppq)
      • 16: outputs the Midi clock divided by 6 (16 pulses per measure/ppm or 4 pulses per quarter note/ppq)
      • 8: outputs the Midi clock divided by 12 (8 pulses per measure/ppm or 2 pulses per quarter note/ppq)
      • 1: outputs a pulse at the start of each measure
    • Other outputs:
      • Start: outputs a pulse at each Midi Start or Continue message or generates a gate signal that remains in the high state until a Midi Stop message occurs (selectable via jumper)
      • Stop: outputs a pulse at each Midi Stop message
      • Reset: outputs a pulse at each Midi Start message that follows a Midi Stop message
      • Wait control input, can be selected by means of a jumper between Gate function or Switch function: in Gate mode the positive edge of a gate signal is used to init the Wait state, in Switch mode an external switch that connects to GND is used to init the Wait state (equivalent to Switch-Trigger)
    • Wait button / Wait control input: Whenever the Wait button is operated or a positive voltage is applied to the Wait input the module waits for the next measure start until the clock signals are generated.  
    • LED displays for clock, "1" and start (display of Start depends upon the chosen Start mode, see above)
    • output voltages can be selected between +5V and +12V by means of an internal jumper (for DIN Sync applications +5V has to be used !) 
    • firmware updates via USB (provided that there will be updates available) 

    Specifikáció: A-190-8 MIDI/USB-to-Clock/Start/Stop

    Megvalósított funkciók MIDI CV
    Szélesség (HP-ben) 6
    Eurorack Igen

    Ezeket a termékeket nézted legutóljára: